Adjustable Alarm or Overtemperature Protection (OTP) setting can be used to protect the furnace or loaded chamber from excessive heat
Thermocouple break protection cuts power to the heating elements, preventing a thermocouple failure runaway condition
Counter-weighted door swings upward, directing heat away from operator
Four individual embedded elements in special refractory cement permit excellent heat distribution in the chamber
Door safety switch protects operator by removing power to the heating elements upon opening the door
Rear-mounted 0.38in. (0.95cm) diameter port for monitoring chamber temperatures with independent measuring devices
LED display simultaneously shows both setpoint and actual furnace temperatures in either or (programmable models only)
Single-setpoint Controller (B1):
Single ramp to setpoint and a dwell
Single display shows actual temperature or setpoint
8-step Programmable Controller (C1):
Ramps to vary heat-up rate and dwell cycles to hold temperature at set levels from 0.1 to 999.9 minutes
Holdback feature-holds program until furnace temperature heats up or cools down to preprogrammed parametersprogram will never outrun furnace performance
Oven, Platinel II thermocouple and a ceramic hearth plate to protect the bottom heating element.
120V models require fixed wiring and are not supplied with a power cord.
Warranty: 1 year